J-stringers   October 17th, 2010

The J-stringers run the full length of the tailcone.  There are two on each side and two on the top.  in order to fit between the skin and the bulkheads, the ends need to be modified as shown in the drawings.

I decided to leave the ‘tab’ a little wider than indicated, because it looked like the dimensions on the drawing would end up causing the rivet holes to be too close to the edge for my taste.

This entry was posted on Sunday, October 17th, 2010 at 9:25 pm and is filed under Tail cone. You can follow any responses to this entry through the RSS 2.0 feed.Both comments and pings are currently closed.

No Responses